Hardware

Dead pixel test

Fill your screen with solid colors, one after another, to find dead and stuck pixels. Run it on a new monitor, laptop, phone or TV while you can still return it, or on a used one before you buy.

Runs in your browser. Works on monitors, laptops, TVs, phones and tablets.

The test fills your screen with one solid colour at a time. Look closely for a dot that does not match: black on a light colour, or bright on black.

Or start from a colour

    During the test: tap or press → for the next colour, tap the left edge or press ← to go back, press Esc to finish.

    How to use it

    1. Clean the screen first, so you do not mistake dust for a pixel.
    2. Press Start full-screen test. The page switches to full screen and shows black.
    3. Look over the whole screen from about an arm's length, then tap or press the right arrow for the next color.
    4. Go through all nine colors. Use the left arrow to go back to one you want to check again.
    5. Press Esc or Exit when you are done.

    Questions

    What is the difference between a dead pixel and a stuck pixel?

    A dead pixel stays black whatever the screen shows, so it is easiest to see on white. A stuck pixel stays lit in one color, often red, green or blue, and shows best on black or on a different color. Stuck pixels sometimes recover; dead pixels do not.

    Can a stuck pixel be fixed?

    Sometimes. Some stuck pixels clear on their own after the screen has been on for a few hours. Pressing on the panel can damage it, so leave that to a repair shop. Pixel fixer videos flash colors rapidly over the spot. Avoid them if you or anyone watching is sensitive to flashing light. A dead pixel cannot be fixed with software.

    I found one. Can I return the screen?

    Check your retailer's return window first, since that is usually the easiest route. Many manufacturers also publish a pixel policy that says how many faulty pixels a screen needs before they replace it under warranty. Note where the pixel is and on which color you saw it.

    I see light at the edges on black. Is that a fault?

    That is backlight bleed or IPS glow, both common on LCD screens and most visible in a dark room. Some is normal. Bright patches you can see in daylight are worth reporting. OLED screens have no backlight, so they should show none.

    Does the test work on phones and TVs?

    Yes. On a phone, turn the brightness up and tap through the colors. Safari on iPhone may not allow full screen, in which case the test covers the page area; turn the phone sideways to hide the bars. On a smart TV, open this page in the TV's browser.

    Advertisement